Use the Baby Quasar - Wash your face and remove any makeup before beginning treatment. Also, if you have piercings in your face, remove them.
Use the Pure Silk Ha Serum that came with your Baby Quasar. Follow the directions on the bottle for proper application.
Use the Baby Quasar
Visually divide your face into six sections. Imagine a line down the middle of your face, one across your eyebrows and one below your nose. This will make six rectangles to work with. For ease of identification, going clockwise, the top left is A, top right is B, middle right is C, bottom right is D, bottom left is E, and middle left is F.
Choose the correct mode based on your skin type. Use low frequency if you have sensitive skin. This is the orange LED light. Use the high frequency if you have normal skin. This is the red LED light and it will not pulsate.
Keep the wand on your skin and start with section A. Move the wand continuously and slowly, do not stop. Do not use too much pressure, but make sure you do not see the light from the wand. You should go over the section for two minutes, until you hear the tone that indicates it is time to go to the next section of skin. Repeat this step for sections B, C, D, E, and F respectively.
The Baby Quasar is a commercial device that you can purchase at department stores and online. It uses red and infrared lights to treat age lines and acne. You can use a combination of three settings to revitalize your skin similar to the way spa treatments work; however, by using your Baby Quasar, you could save a considerable amount of money versus going to the spa, and can provide your skin several treatments a week for faster results. Does this Spark an idea? - by eHow
Label: